AudioREVIEW's Forum Archives - All About Speakers


Archive Home >> All About Speakers(1 2 3 4 5 6 7 8 9 10 11 12 ) >> Crossover Update for the AR.com DIY Kit Speaker(4 posts)


Crossover Update for the AR.com DIY Kit SpeakerEFE
Dec 12, 2002 3:38 PM
AudioReview.com DIY Kit Crossover Update

It has been brought to my attention that some Do-It-Yourselfers out there have measured the AR.com DIY Speaker and found it to have a 3-4db dip in the frequency response at the crossover point (3khz). I was aware of this when I designed the kit but chose to let it go for the affect it presented, a little deeper and backset soundstage. Since some have requested to eliminate this frequency dip in the crossover, I am posting this notice to them as well as others who might want to increase the accuracy of the speaker.

Replace the .15mh inductor on the tweeter with a .3mh (4 ohm DCR). The part number from MCM Electronics is 50-320. Also add a 1 ohm (10watt) resistor across the leads of the .4mh inductor on the woofer secondary circuit. Parts for both speakers should be no more than $6.

Use only the recommended 5 ohm resistor rather than the 4 ohm as stated in the instructions, the 5 ohm is more natural with or without a subwoofer in the system.
Success!

Ed Frias
EFE TECHNOLOGY Speakers
EFESPKRS@aol.com
Sorry, correction! .4 ohm DCR ntEFE
Dec 12, 2002 4:57 PM
nt
While we're on the subject...StevenSurprenant
Dec 13, 2002 2:16 PM
I am thinking about building your DIY and thought that while I'm at it, I would go ahead and use better crossover components.

Any suggestions?

I recieved the documentation you sent concerning your other speakers and was very impressed with what I read, but I thought I'd try the DIY first to see if my tastes are the same as ALL the posters. Everything sounds very good...

Best wishes during the holidays...

Steve
While we're on the subject...EFE
Dec 13, 2002 6:54 PM
Hi Steve,
Use the exact parts called for in the kit from MCM and Madisound, cabinets from Speaker City. If you choose to buy the crossovers finished, Madisound sells them for around $52pr (good buy). Make sure to use the 5 ohm resistor on the tweeter. Success!

Ed Frias
EFE TECHNOLOGY Speakers
 


Archive Home >> All About Speakers(1 2 3 4 5 6 7 8 9 10 11 12 ) >> Crossover Update for the AR.com DIY Kit Speaker(4 posts)
 MtbREVIEW.com  RoadbikeREVIEW.com  OutdoorREVIEW.com
 PhotographyREVIEW.com  VideogameREVIEW.com  ComputingREVIEW.com
 AudioREVIEW.com  CarREVIEW.com  GolfREVIEW.com
Copyright ©1996-2008 All Rights Reserved.ConsumerREVIEW.com, a division of E-centives, Inc.